1. When in use, the lifting belt is directly hung into the force center of the hook, and directly hung in the tip position of the hook.
2. The lifting belt is not allowed to cross, twist, knot and twist in use. The correct lifting special link piece should be used to link.
3. In the process of use, it must be directed by personnel with relevant qualifications. Overload is strictly prohibited.
4. When the two lifting belts are working, the two slings are directly hung into the double groove, and each is hung in the position of the symmetric force center of the double hook; When the four straps are used, every two straps are directly hung into the double hook, pay attention to the Belt Webbing straps can not overlap and squeeze each other, and the lifting Belt should be symmetrical to the hook force center.
5. It is strictly prohibited to use lifting belt on rough surface. Belt Webbing when the load has sharp corners, edge of the goods, must use sheath, Angle protection and other methods to protect the sling, in order to extend the service life of the lifting Belt and eliminate safety risks.
6. When a single hoisting belt is needed to lift the cylinder, double choke ring should be used to bind it.
7, because the bending part of the hook using flat lifting belt in the width direction can not be evenly loaded, affected by the hook strength. The hook diameter is too small, and the Belt loop eye joint is sufficient, Belt Webbing should use the correct connection link.
8. Correct hoisting method should be adopted when hoisting pipe objects, and the hoisting Angle should be less than 60.
9. The object should not be pressed on the lifting belt, and the lifting belt should not be pulled out from below to cause danger. Apply the object cushion, leaving enough space for the lifting belt to come out smoothly.
10. The opening Angle of the ring eye of the circular hoisting belt should not be greater than 20°, and the ring eye should not be broken during the hoisting process.
11. After using the hoisting belt, the suspension storage method should be selected.
Post time: Aug-04-2022