The use of Safety Belt Webbing is as follows:
1. Check the Safety Belt Webbing and hold the D-ring buckle of the back pad of the Safety Belt to ensure that the Webbing is not tangled together.
2. Start wearing the seat belt and slide the seat belt over your arms to your shoulders. Ensure that all webbing is free of tangles and free to hang. The straps must be vertical and not close to the center of the body.
3. Leg webbing grab the leg webbing and connect them with the buckle on the webbing on both sides of the hips. Thread excess length of webbing into adjustment ring.
4. The chest ribbon is connected together by a set of buckles. The chest strap must be 15cm below the shoulder, and any excess length of the webbing should be inserted into the adjustment ring.
5. Adjust Safety Belt Webbing. Shoulders: Adjust the webbing all over your body from the shoulders, making sure the leg webbing is just below your hips and the D-ring on your back is between your shoulder blades.
General high altitude seat belt options:
1. The security
When buying Safety Belt Webbing, consider Safety first.
2. The comfort
Users must be aware of the risk of falling in their workplace and choose a suitable seat belt based on the risk of falling in use. Fall-suspension seatbelts, which are full-body seatbelts with leg straps, must be chosen in any situation where there is a risk of falling.
A separate belt should only be used for work limits and should not be used where there is a risk of falling; Otherwise, in the event of a fall, the body will be out of balance and vulnerable to collision. At the same time, the impact of the fall is concentrated in the waist, which is most likely to cause spinal fracture, internal organ rupture and other serious injuries.
3. Length of rope to match seat belt
For high-altitude safety belts equipped with safety ropes, the length of the safety rope should not exceed 2 meters, otherwise the user may fall freely, the distance is too long, and the impact force may exceed the human body's tolerance limit.
Selection of high altitude safety belt under special circumstances:
1. When working under special circumstances, such as welder working at height, safety belt made of flame retardant material must be selected. Conventional seat belts can be damaged by contact with welding slag or sparks and will not provide protection against fall.
2. Roof and tank top operation. As long as you're not over the edge, you can't fall. The operator's movement area is restricted by a limit tether (belt), in which case a limit belt or other type of safety belt may be used.
3. Use a ladder to perform operations. The operator needs to face the ladder when climbing, and the safety belt is connected with the anti-fall device on the ladder. This operation is required for at least a double harness as there is no single strap ring on the front of the harness.
Post time: Jun-07-2022