We help the world growing since 1983

The characteristics Lifting Sling Belt of the lifting belt and the matters needing attention

Lifting Sling Belt features

1. Protect the hanging object, so that the surface of the hanging object is not damaged.

2, high strength, light weight, easy to carry, reduce working intensity.

3, soft and easy to operate.

4, non-conductive, no Mars in flammable environment.

5, no rebound, reduce the reverse harm to people.

6. High corrosion resistance and fatigue resistance.

7, you can judge the bearing tonnage according to the color.

Precautions for using Lifting Sling Belt:

1. The hoisting belt fiber should be prevented from mechanical damage, and avoid contact with the sharp edge and rough surface of the lifting weight or friction heat generation.

https://www.suoliwebbing.com/products/

2. In use, the Angle between the two cables of the fiber cable eye shall not exceed 30 degrees, and the Angle at the joint of the hoisting belt soft cable eye shall not exceed 20 degrees.

3. Fiber sling and hoisting belt shall not be dragged and rubbed on the ground, and the surface shall not be stained with sharp particles such as sludge sand.

4. After the sling or lifting belt is polluted by corrosive medium, it should be washed with water in time. After being wet, it should not be heated and dried, but can only be dried in natural circulating air;

5, when the use of moist polyamide fiber rope sling, lifting belt, its ultimate working load is reduced by 15%.

6, all kinds of fiber sling, hoisting belt should be adapted to the use of the environment, to prevent environmental corrosion, natural fiber shall not contact acid and alkali and other corrosive media; Man-made fibers shall not contact organic solvents; Polyamide fibers should not be exposed to acidic solutions or gases; Polyester fiber must not contact with alkaline solution; The hoisting belt of the fiber sling shall not contact the non-contact substances specified in the instruction manual;

7. The Lifting Sling Belt and Lifting Belt should not be used in environments other than the temperature specified in the product Lifting manual, and should not be used in heat sources or welding workplaces.

 

8. It is not allowed to centrally use the bolt lifting method without protection.

9. It is not allowed to connect the soft ring with any device that may cause damage to it. The lifting device connected by the soft ring should be smooth, without any sharp edges, and its size and shape should not tear the suture.

10. Do not knot the lifting belt. In the load, do not allow to make it twisted.

11. It is not allowed to use lifting belt without sheath to carry goods with sharp corners and edges, especially when the belt is partially scraped or worn.

12. The lifting belt is not allowed to hang the goods for too long. When the goods stay on the lifting belt, the lifting belt is not allowed to be pulled out from the bearing state.

13, avoid soft ring opening Angle more than 20°.

14. The load should be kept constant during lifting. If several lifting belts are used at the same time, the load should be evenly distributed on each lifting belt as far as possible.

15. The lifting belt should be stored under the condition of avoiding light and no ultraviolet radiation; Lifting belts should not be stored near open flames or other heat sources.

16, the relationship between the color of synthetic fiber lifting belt and the frontal load:

In order to prevent improper use of the limit working load mark of the sling, the sling itself is distinguished by color: purple is 1000kg; Green is 2000kg; Yellow is 3000kg; Silver gray is 4000kg; Red is 5000kg; Blue is 8000kg; More than 10000kg is orange.


Post time: Aug-03-2022