The standard use of hoisting belt is an important link related to safety production. In recent years, an increasing number of customers of Webbing Sling Belt Supplier have made safe use of lifting straps a top priority in their production process.
1. The Sling must be checked before each use to check whether there is any transverse surface of the Sling, the supplier of the Webbing Sling Belt scratches or cuts it from the direction, whether there is any damage to the edges, soft rings and end parts, and whether the Sling is in good condition before lifting.
2. Strictly observe the hoisting method coefficient (see Appendix A) and use the sling correctly.
3, lifting workpiece surface should be smooth, no sharp corners, burrs and edges, apricot should use the sling special sheath and Angle protection. It is forbidden to use the sling to lift objects with sharp corners, burrs and edges directly.
4. If the bandwidth is greater than 75mm, the diameter of the supporting parts shall not exceed 1/3 of the inner length of the soft ring. If the bandwidth is less than 75mm, the Webbing Sling Belt supplier can use the soft ring to directly connect the carabiner to hang. However, the curvature radius of the carabiner shall not be less than 0.75 of the bandwidth.
5. It is not allowed to centrally use the bolted hoisting method without protection .
6. The soft ring shall not be connected with any device that may cause damage to it. The lifting device connected by the soft ring shall be smooth, without any sharp edges, and its size and shape shall not tear the suture or overload the belt.
7. When moving the Sling and goods, the Sling shall not be dragged anywhere to avoid damaging the Sling surface supplier.
8, in the bearing shall not be tied or twisted in the state of lifting.
9. It is forbidden to suspend goods with sling for a long time.
10. When the goods stay on the sling, the sling shall not be pulled out from the bearing state to avoid damage to the sling.
11. The sling should avoid being suspended by other objects or subjected to other impact loads in the process of lifting.
12. The opening Angle of the soft ring of the sling shall not exceed 200.
13. Loading condition shall not be changed during lifting. If several suspenders are needed at the same time, cloth on each suspender if possible Webbing Sling Belt supplier.
14. It is forbidden to connect or lengthen the sling in a knot way.
15, sling in the use of as far as possible to avoid acid, alkali and other chemical contact, avoid the use of high temperature and Mars splash place. If the sling is dirty or used in an acid or alkali environment, it should be immediately washed with cool water.
A, polyamide (nylon) : moderate strength of acid corrosion; In humid environment, the strength decreases by about 15%; Not affected by alkali; Ultraviolet light will accelerate its aging.
B, polyester (PES) : in alkali will be damaged; It has moderate acid corrosion resistance.
C. Polypropylene: Acids and bases have little effect on it.
16. When not in use, the sling should be placed on the special storage rack (place). Sling should not be placed in a pile near open flame, open flame or other heat sources. Do not leave in the hot sun for long.
17. After daily use, the grease on the sling should be wiped clean with water and placed on the special storage shelf.
Post time: Aug-18-2022