1. During the operation of two hoisting belts, hang the two hoisting belts directly into the double hooks. The lifting belt is hung in the symmetrical bearing center of the double hook; When the four hoisting belts are used, each two hoisting belts should be directly hung into the double hooks. It should be noted that the hoisting belts inside the hooks cannot be stacked or kneaded each other, and the hoisting belts should be symmetrical to the stress center of the hooks.
2. When in use, hang the lifting belt directly into the bearing center of the hook, not on the tip of the hook. The lifting belt is not allowed to cross, twist, knot, twist, should use the correct lifting belt special connectors to connect. When loading goods with sharp corners and edges, it is necessary to adopt methods such as sheath and Angle protection to maintain the lifting belt, so as to extend the service life of the lifting belt. It is strictly forbidden to use Flat Polyester Webbing Sling on rough surface. To prevent the Webbing Slings from being cut off by edges and rough surfaces.
3, when using, because the bending part of the hook makes the flat lifting belt can not bear uniform load in the width direction, which is affected by the inner diameter of the hook. The diameter of the hook is too small, and the combination of the ribbon ring is not sufficient,Double Eye Flat Webbing Sling the correct connector should be used to connect.
4. Items should not be pressed on the lifting belt, which will cause damage to the lifting belt. They should not try to pull out the lifting belt from below, which will cause danger. Use the object to pad up, leaving enough space for the lifting belt to come out smoothly.
Post time: May-14-2022